UPDATED VERSION !!

1) New 36A ESC for improved durability in all conditions
2) Tinted real canopy for better scale appearance
3) Strengthened internal undercarriage mounting for better rough field durability
4) Side thrust to offset torque in hovering and low speed manouevres

Want a sports aerobatic model that is economic to buy, economic to operate and stunning to fly? You've just found it !

The ST Models MX-2 is based on the full size, aerobatic aircraft of the same name and then modified for model flying characteristics.

Supplied complete with powerful 920 Kv brushless motor, 12 x 6 propeller, a 36 A brushless ESC, four powerful new 9 g servos and with them all pre-installed. All that is needed is 30 minutes of final assembly and applying the stunning colour decals.

Setups are provided for both sports and 3D flying (even mixes). For serious 3D pilots, the movements make maneouvres like static loops, rolls and the 'waterfall' and 'parachute' quite within your reach.

To provide that 3D control power with precision has been achieved with a totally new servo amplifier to give high resolution and holding power combined with strong torque. The control pushrods are kept short by placing each servo close to the surface it is operating.

Using a 3S 2100-2500 mA Li-Po, there is enough power to hover vertically with ease and then punch out straight up! The choice of a 12 x 6 propeller limits the 'torque' turn effect and eases current consumption by matching the load and motor power/Kv rating effectively. Torque rolls are possible in both directions. Access to the battery is via a clip-in underside hatch, simple!

Like all ST models, the airframe is moulded accurately in 'ding' resistant EPO foam. The wings are removable by removing the two quick turn locking screws and sliding out of the fuselage, great for compact transportation. Access to the radio compartment requires pulling off the clip-on canopy moulding.

The tough, aluminium undercarrige soaks up those landings on our club patches so well, but the model is hardly moving forward anyway!

As a model to hone your aerobatic skills or just cruise around on a Sunday afternoon, the ST Models MX-2 is hard to beat.

And it looks 'cool' too !

Specifikacija:
Raspon krila: 1210 mm
Dužina: 1106 mm
Površina krila: 27.3 dm²
Opterećenje krila: 35.2 g/dm²
Težina: 960 grame

RC funkcije:
- Pravac-Rudder
- Visina-Elevator
- Nagib-Aileron
- Motor-Throttle

Kit sadrži:
- Model od Arcel
- Motor outrunner brushless 920 kv postavljen
- Regulator ESC brushless 36 A postavljen
- Elisa 12 x 6" + spiner
- 4 x Servo 9 g NANO postavljeni
- Komplet set delova za montažu
- Detaljno uputstvo montaže sa slikama

Za pokretanje modela potrebno je:
- Radio stanica min. 4 kanala
- Baterije za radio stanicu
- Baterija LiPo 11.1V/ 2100 - 2500 mA
- Konektori za bateriju i ESC
- Punjač za baterije sa odgovarajućim kablovima